FTDI DUAL CHANNEL BREAKOUT BOARD

Dual Channel FTDI Breakout Board

The FTDI
DUAL CHANNEL BREAKOUT BOARD

This breakout board is based on the FTDI FT2232H USB 2.0 IO chip. The FT2232H
is a USB to serial converter, but with a lot more features. There are two independent
serial ports in the chip. Each port is individually addressable and does not
interfere with to other port. It uses the best in class FTDI CDM Driver. Just
connect it to a USB port on a PC and the driver creates two ports.

The FT2232H Breakout Board contains the MPSEE engine. This engine can output
SPI, I2C, JTAG or act like an eight bit parallel port. Using the JTAG interface,
the FTDI Breakout Board can program the ATMega and Arduinos. It is supported by
OpenOCD, urJTAG and others.

Hardware Features:

USB 2.0 Hi-Speed (480Mb/s)
2 Independent USB to serial ports
2 MPSSE modules with I2C, SPI, and JTAG
General purpose IO pins
3.3volts
Supported JTAG debugger in OpenOCD, urJTAG, and others
Multi-platform support, GPL drivers

The breakout board includes an external EEPROM for custom USB descriptors and
VID/PIDs, Serial Numbers, Driver selection (Virtual COM Port or D2XX drivers).
There are two 13x2 Headers on 0.1 inch pitch installed on the bottom of the board.
An external +3.3V LDO provides power for the FT2232H chip as well as powering off
board electronics. The FT2232H chip can operate up to 12MBaud data transfer rates
via USB 2.0. It features the USB Micro-B connector.

Downloads

85-000001	Dual Channel FTDI Breakout Board User Manual	DUAL_CH_FTDI_BREAKOUT_UM.pdf
95-000001	Dual Channel FTDI Breakout Board DataSheet	DUAL_CH_FTDI_BREAKOUT_DS.pdf
55-000001	Dual Channel FTDI Breakout Board Schematics	DUAL_CH_FTDI_BREAKOUT_SCHEMATIC.PDF
35-000001	EPT Drivers	EPT_2.12.00.exe

$29.00

Quantity

quantity

18 in stock

$29.00 Price

Shipping: $4.00

Updating cart...

Sorry, the comment form is closed at this time.