Forum
Notifications
Clear all
After copying jtag_hw_mbftdi_blaster64.dll to the quartus/bin64 folder for both 18.1 and 21.1.1 from the DueProLogic DVD 4.0, Quartus does not display the MBFTDI-Blaster v1.6b(64) (or anything else) in the hardware setup window. The US says "see the JTAG DLL Insert to Quartus Prime Troubleshooting Guide". Where's that? All other drivers are installed correctly. I cannot program my DueProLogic !!!! Help. (W10, Alienware M15, x64)
Thanks
Topic starter
Posted : 15/12/2022 3:56 pm
Did you solve it? I am having the same issue. Compiled some verilog code fine, but when it comes to programming the cpld the device does not appear in quartus programmer. Using quartus prime lite 20.1 on windows 11.
I've installed FTDI drivers, and in device manager under "Ports (COM & LPT)" there appear two devices e.g. USB Serial Port (COM11). They come and go when I plug the board, and clicking them shows Manufacturer: FTDI.
But as for quartus programmer, Hardware setup shows "no hardware". Running jtagconfig.exe says "No JTAG hardware defined".
Posted : 02/03/2024 11:14 pm
I also am having this issue. Did you figure it out? Any insight would be greatly appreciated!!!
Posted : 04/05/2024 11:45 pm
The issue seems to be with the JTAG driver setup in Quartus. The troubleshooting guide mentioned in the error message may help resolve the problem with the missing MBFTDI-Blaster driver. If the guide doesn't work, you may need to contact DueProLogic support.
Connect and explore the world with our exciting new omegle website experience!
Posted : 13/05/2024 6:25 am
Try Check if jtag_hw_mbftdi_blaster64.dllDueProLogic incredibox is compatible with your Quartus Prime version (18.1 or 21.1.1 ). The DLL may be version-specific. Consult DueProLogic documentation or support to confirm.
Posted : 31/05/2024 8:35 am
