‌
‌
‌
‌
‌
‌
‌
‌
‌
‌
‌
‌

It is designed to program Arduinos.

Its six pin female header connects easily to a Mini Pro with no bread board needed. It has one green LED that indicates power is applied to the FTDI chip. There are two amber LEDs to indicate when Tx and Rx are active.

The VisiPort works with 5Volt and 3.3Volt Arduinos

Use the three pin jumper in the upper right corner to select I/O voltage of the VisiPort. This selection allows compatibility with all Arduinos.

The VisiPort Uses a Micro USB Connector

The Micro USB connector is lower profile and allows cables to connect into the center of the VisiPort. This keeps the overall size smaller than any other programmer.

What's the difference between VisiPort and other programmers?

• We made the VisiPort as compact as physically possible
• We used a Micro USB connector instead of the Mini USB
• The VisiPort is compatible with 5V or 3.3V Arduinos
• The VisiPort can power your board up to 280 mAs at 3.3V or 480 mAs at 5V
• We gave the VisiPort jumper selectable DTR or RTS reset capability
• We also gave the VisiPort a USB disconnect switch which allows you to turn off the serial port path to the PC and communicate over the serial port to any device with removing the USB cable.

The VisiPort is the perfect tool for debugging microcontrollers. Use it to download your compiled hex file to the flash (using the bootloader of the microcontroller). Use it to communicate with your code and provide debug information about the execution process.

Hardware Features:

• FTDI FT232R USB To Serial Chip
• User Selectable +3.3V and +5V Inputs/Outputs
• Provides up to 450 mA of power for your Arduino
• User Selectable RTS/DTR for programming Arduinos

Downloads